Ductless Mini-Splits in Windsor

Ductless Mini-Splits for Windsor homes

Windsor's homes range from early-1900s brick houses with radiators in Walkerville and the older core to post-war bungalows and newer subdivisions in the east and south ends. Windsor's older homes with radiators are prime mini-split territory. Walkerville and the older core are full of brick houses with hot water heat and no ductwork, and a two- or three-zone ductless system gives them real central-air comfort without tearing into plaster walls.

What's included

Ductless heat pumps for additions, garages, finished basements and homes with radiators, with one or several indoor zones. Depending on your home and equipment, the work can include:

• Homes with radiators
• Additions and sunrooms
• Bonus rooms and upper floors
• Finished basements and garages
• Homes on electric baseboard
• Room by room.
• Head placement.
• Line set routing.
• Outdoor unit.
• Electrical.

Full details, how the work runs and common questions are on our main ductless mini-splits page. Want a ballpark first? Try the instant system estimate.

Local conditions in Windsor

Long, humid summers make cooling a necessity in Windsor rather than a luxury. Removing humidity matters as much as lowering the temperature, so we size equipment to run steady cycles, and we use ductless systems in homes with radiators where running ducts isn't practical.

Questions to ask before you hire

Whoever you hire for ductless mini-splits in Windsor, get clear answers to these before signing:

• How did you size each indoor head for its room?
• Is this a cold-climate model for winter heating?
• Where will the line sets and drains run, and how will they be covered outside?
• How often should the indoor units be cleaned?
• Who does the electrical work?

Permits and licensing

Building permits in Windsor are issued by the City of Windsor's Building Services department. Some HVAC work, such as new ductwork in renovations or changes that affect the building structure, may need a permit, while gas appliance installations must be done by a TSSA-registered contractor and electrical work by a licensed electrical contractor. We confirm what applies to your project during planning.

More from Kelvin Heating & Cooling in Windsor

People planning ductless mini-splits in Windsor often look at related work too, including heat pumps, boiler services, AC installation. We also provide ductless mini-splits in LaSalle and ductless mini-splits in Tecumseh. See every service we offer on our Windsor service area page.